$2,336.00
Asetek Racing La Prima Direct Drive Wheelbase 12Nm
Asetek Racing La Prima Formula Steering Wheel (Orange)
Asetek Racing Forte Sim Racing Pedals (Brake & Throttle)
Asetek Racing La Prima Clutch System
Software and Platform
Asetek Racing RaceHub is used to update firmware and set up every device in the bundle, from wheelbase force feedback and profiles to button mapping, rev lights and pedal calibration.
This Asetek Racing bundle builds a complete three-pedal La Prima Formula setup: the La Prima 12Nm direct drive wheelbase, the La Prima Formula Steering Wheel in orange, the Forte brake and throttle pedals and the La Prima Clutch System. It is aimed at drivers moving up to direct drive who also want a clutch for manual shifting, heel and toe or clutch starts. Compared with the two-pedal starter bundle, it adds the clutch; other sibling bundles swap in the hydraulic Invicta T.H.O.R.P. II pedals or include the Boost Kit for 16 Nm of torque.
The wheelbase delivers 12 Nm of peak and holding torque with a 4 Nm/ms peak slew rate, and its 22-bit encoder resolves 0.000085 degrees, about 4,000,000 steps per revolution, with no cogging or lag. The 290 mm Formula wheel brings 12 push buttons, two 7-way switches, three 12-position rotary encoders, two thumb encoders, magnetic shifter paddles and 15 aRGB RevLEDs. The Forte pedals use the two-stage M.L.C.P.C. load cell brake, reaching 180 kg at the pedal plate with a firm, short travel, and a contactless 16-bit Hall throttle. The clutch reads through a 16-bit wireless magnetic Hall sensor, with four mechanical pedal curve settings and a bite point set in RaceHub.
The wheelbase has an anodized extruded aluminum housing, a slipring tested to more than 200,000,000 rotations and the Asetek Racing quick release, which carries data and power to the wheel without cables, batteries or wireless signals. Its rear USB ports act as a hub, so the pedals plug straight into the base. The clutch slides onto the Forte pedal set with two screws and a small electrical connector, and its die-cast aluminum arm is designed for 200 kg of force. Everything is set up in RaceHub, from force feedback profiles to button mapping and pedal calibration. Please note a cockpit or wheel stand to mount the setup is sold separately, and the bundle works with PC (Windows 10/11) only.
